Chlorine granules, 1 kg

Spa Chlorine Granules 56% is used for effective disinfection of bathing water in outdoor and indoor spas, wilderness baths and smaller garden pools.

Instructions for use: Always first adjust the pH value of the bath water to 6.8 -7.2*. This is where the bath water is most pleasant and Activ Spa Chlorine Granules will disinfect optimally.

Dosage: When refilling: Add 9 grams of SPA chlorine granules per 1000 liters of bath water. The bath water must then be measured regularly and the chlorine content must be kept between 2-5 ppm (mg/l).

It is recommended that Spa Chlorine Granules be dissolved in a clean plastic container with water. Add water first. Pour the solution into the spa water while the circulation pump is running.

Alternatively, spa chlorine granules can be carefully sprinkled directly into the spa water in front of the nozzles, provided that the circulation pump is running. Let the circulation run for at least 20 minutes after addition.

Warning: Mixing different chlorine products can lead to violent reactions and explosions! Never mix with other chemicals! Use biocidal products safely. Read the label and product information first.

*According to the Executive Order on swimming pool facilities etc. and their water quality, Appendix 1, the pH value should be between 6.8 and 7.0. The value must not be below 6.8 and never above 7.6. Water in Denmark is calcareous, and therefore has a relatively high pH value. The use of pH-increasing agents should not be necessary. You can optionally replace some of the water with tap water.

Chlorine granules require care when handling and storing. Use plastic/rubber gloves and only open in a well-ventilated area or outside.

Store safely, out of reach of children and not together with food, feed, medicines, etc. Must be stored in a dry, cool and ventilated place. Should be stored in tightly closed original packaging. Must not be stored together with the following: Strong acids.
See safety data sheet