The filling time is limited to a maximum of 240 minutes (can be set). This “security guard” prevents the water from running in the event of faults on sensors or cables. Only for new spas The price for this module is when fitting into our workshop in a newly purchased spa. If you wish to purchase the module for an older spa, a service module must be added to the price. Call for an offer. What is included in the price? The SPA company assembles the unit, and sensor that detects the maximum water level as well as a 3/4 inch external threaded tee which is mounted in the nozzle piping system. Your HVAC installer connects the water supply T-piece with a solenoid valve (3/4 inch NC 230V. Not included), filter, and check valve. The solenoid valve is connected to the water tap. Your electrical installer supplies and installs the switch that supplies, power to the unit.
Technical data Supply: 230V ac, 50-60Hz Terminals PE-L-N
Output: 230V ac. Max 2.2kW AC-3 load (solenoid valve) N-U-PE
Filling time (reset): 10-240 minutes. Adjustable Switches off the solenoid valve after max. 240 min. Security guard
Delay: 0-20 sec. Adjustable. Used when only 1 sensor is mounted.
Sensor: (not included) Float (magnetic) or capacitive types 1 or 2 pcs. can be connected.
Signal lamp: red / green LED
Dimensions: L 156 x H 78 x W 115 mm
Cable glands: 2 pcs. PG 7, 2 pcs. PG 9, IP54
Kit contains: Control unit, sensor, 3/4 inch tee with external thread
This product does not contain automatic bottling. Automatic tapping can be made using a 2-way solenoid valve, which e.g. is switched on by a timer.