Oslo is the hot tub with many possibilities. It can be used as both a spa, and as a permanent spa (tubs where the water stays in, as in a swimming pool). It can be used as both indoor, and a outdoor spa, and it can be set up above ground, or it can be built in. Therefore, Oslo outdoor spa is very suitable for the rental industry.
Finance and control
Behind the cabinet on the underside of the spa is a timer function. This controls the circulation pump, the filtration system and the flow of water through the heater. The timer is only used if you want to use the tub as a spa (a spa where you keep the water, as in a swimming pool). You can set the timer to heat the water at all times or after certain times.
Built-in filtration system
This spa is equipped with skimmer and a filtration system which contributes to a better water quality. It also allows the spa to be used as an outdoor spa (a spa where you keep the water, as in a swimming pool).
Reliability
Electronics and water are separated in this pneumatically controlled hot tub. This form of control is reliable and can withstand the sometimes harsh treatment a rental spa is exposed to. All complicated programming that often characterizes electronic controls has been removed in favor of a simpler and more reliable control.
Fun and wellbeing
Oslo is equipped with a waterfall that is controlled on the edge of the spa. This contributes to a relaxing and luxurious atmosphere. In addition, the waterfall adds oxygen to the water, which helps to maintain a good water quality.
Quick emptying of the spa
The spa is equipped with two drains; one through the vertically located drain and one at the bottom of the spa. This ensures easy and efficient maintenance and emptying of the water in the spa.
Specifications
Dimensions: Diameter 182 cm x H: 80 cm
Number of seats: About 5 seats
Color: Pearl
Color cabinet: Antracit, PVC
Stand: Solid maintenance-free PVC
Base plate: Molded PVC
Tub: Molded sanitary acrylic
Water volume: About 600 liters
Weight: 200 kg
Insulation: The underside of the spa: 2-3 cm foam insulation.
Sides: 5 cm insulation on three sides, serviccover; 3 cm insulation. All insulation is reinforced with heat-reflective foil.
Cover: Foamed polystyrene. Extra strong top cover, 9 cm thick in the middle with slope to 5 cm. Slate color.
Control panel: Balboa control system with antifreeze & economy mode
Timer: Built-in timer function
Heater: 3 kW.
Cirkulation pump: 1 pc. (180 W)
Jet pump: 1 pc. (2 hk)
Total number of massage jets: 17 pc stainless
Waterfall: Controlled on the edge of the spa
Light: Yes, white
Ozonator: Yes
Filter: 1 pc slats
Connection: 400 V, 16 A | Connected with a 5 pole CCE MALE connector
Information for Electrician: Bring a 5 pole CCE FEMALE plug
WARNING!
Turn off the power before refilling and replacing water in the spa. The heater must NEVER run without water in the spa, otherwise it will overheat and break down. An overheating of the heater is NOT covered by the warranty.